SHARE
This tutorial is able to help you oh how to fix bootloop on CM Cubix Cube 2

 

Fix Bootloop of CM Cubix Cube 2


Requirements:
PC
USB Cable
Download Links:
Mediatek VCOM Drivers

Cherry Mobile Cubix Cube 2 Stockrom

 


 Instructions
1. Download all necessary files and Enable USB Debugging mode in your phone..
2. Install Drivers Mediatek VCOM Drivers
In Device Manager Right click on PC name(Right Side) and then click on Add legacy hardware as shown in image below.
SPFT Screenshot 1
Now in Add Hardware Wizard click on Next » Install the Hardware that i manually select from a list (Advanced) » Show All Devices » Next » Have a Disk, Now select the any inf file from where you extracted the downloaded VCOM driver package.
SPFT Screenshot 2
3.  Now Click on Next and select Install this driver software anyway and wait for finishing the process.
SPFT Screenshot 3
4.  After installation is finished then Restart your computer, That’s it.
5. Open flash_tool.exe, click on the Download Tab
Extract the downloaded Jiayu g6 stock rom to the new folder you created.

Click Flash Tool

 

6. Click Scatter-loading and browse for the scatter file (MT6592_Android_scatter)
7. For Bootloop only
Make sure flashing mode is set to “Download Only” and check mark all except Preloader.
Note: If deadboot/hardbrick set “Download+Format” and check Preloader.
8. Click Download.
9. Turn off your phone, connect your phone to the PC and wait for the flashing to commence.
10. Green Circle image with check will show once flashing is completed. That’s it!
11. Disconnect your phone in USB cord then open if still bootloop then try to factory reset in recovery settings. To go in recovery mode reboot your phone hold and press power on and volume up simultaneously until recovery mode appeared.Credits:
Gio for rom
Cube Cubix2 group

1 COMMENT

LEAVE A REPLY

Please enter your comment!
Please enter your name here